Fixture Installation

At Kerrville Plumbing Services, we install and replace plumbing fixtures for homes throughout Kerrville. New faucets, sinks, toilets, tubs, and shower fixtures are fitted carefully to support reliable operation, proper drainage, and a clean finished look.

Fixture installation in Kerrville that includes the line behind the faucet

Call (830) 354-4767 if a faucet will not shut off, a sink is pulling away from the wall, or a new fixture needs to go in on tired supplies.

Faucet installation and sink installation in Kerrville only last if the stops and the supply lines can support them. Kerrville Plumbing Services handles fixture installation and faucet repair from 1660 Junction Hwy, including the valves in the cabinet, not just the trim you see.

Downtown houses along Main Street and Water Street often still have older stops and mixed pipe. Later streets in Comanche Trace and Ridgeland more often have PEX and quarter-turn valves. We open the cabinet far enough to see which one you actually have. You can leave the street and about when the house was built on the Contact page if a short message is easier than a long call.

Decorative background shape
FIXTURE INSTALLATION IN Kerrville
NEW TRIM ON A STOP THAT HOLDS

Kerrville Plumbing Services tests the shutoff and the supply before a faucet, toilet, or sink comes off, so the new fixture sits on a line that will not weep.

Smiling plumber in navy coveralls holding a pipe wrench and an adjustable wrench

Faucet, sink, and fixture repair clues

A handle that will not shut off. Water under the cabinet when no one has used the sink. A spray hose that weeps at the coupling. An aerator that crusts over every few weeks. A sink that moves when you lean on it. Those are fixture problems, and they are also how we decide whether the failure is the faucet or the stop behind it.

What we replace, and what we keep

A sound faucet body with a failed cartridge is a repair. A cracked body, a seized shower valve, or supply lines that stain the cabinet floor are a fixture installation job. We shut the stops, install the new faucet or sink, remake the lines, and run both hot and cold so the cabinet stays dry.

If water is already in the cabinet, call us at (830) 354-4767 before the floor under the sink swells.

When the fixture points to a larger problem

A faucet that will not stay closed can hide a supply leak in the wall. Low hot water at a new tap can belong with water heater repair. A bath fixture that backs up after install may be the drain or the toilet on the same branch, not the trim we just set.

The longer residential list is on plumbing services. A wet cabinet that is already spreading should start on emergency plumbing, and the About and FAQ pages cover the shop and the towns we serve.

Faucet and toilet installation cost in Kerrville

Fixture prices in Kerrville vary with the faucet or toilet you choose and with the condition of the shutoff, flange, or supply line behind it.

ServiceTypical cost in Kerrville
Faucet repair$125 to $300
Faucet replacement$150 to $400
Toilet repair$125 to $350
Toilet installation$250 to $700
Shower valve or cartridge work$200 to $600

These figures are typical ranges for Kerrville and the Hill Country area, not a final bill. The final price depends on the problem, the parts, how hard the work is to reach, and whether the call is after hours. We diagnose on site and give you the number before any repair starts.

Compare these figures with the full list on our plumbing cost in Kerrville page, or call (830) 354-4767.

How much does it cost to install a new faucet in Kerrville?

Faucet installation in Kerrville typically runs $150 to $400 depending on the faucet type and the condition of the supply lines and shutoffs behind it. Older homes with galvanized supply or frozen stops often cost more because those parts need replacing before the new faucet can go on safely.

How long does fixture installation take?

Most single-fixture jobs, like a faucet or toilet, take under two hours when the shutoffs work and the supply lines match. Jobs take longer when old stops are frozen, supply lines are galvanized, or the sink and toilet are both being replaced on the same visit.

Can I install a new faucet myself or do I need a plumber?

Swapping a faucet looks simple, but hidden problems like a frozen shutoff, mismatched supply line, or a cracked valve body often surface mid-job. A rushed DIY install on a bad stop can leave the cabinet leaking behind new trim, which is harder to catch than the drip you started with.

What is the difference between faucet repair and faucet installation?

Faucet repair fixes a sound faucet body with a worn cartridge, seat, or aerator. Faucet installation replaces the whole fixture, which is the right call when the body is cracked, the finish has failed, or the valves and supply lines behind it are already leaking.

Questions about this work

Can you install a new faucet on old shutoffs in a Kerrville house?

Sometimes, if the stops are sound and the supply lines match. In older downtown houses the shutoffs may be frozen, or the supply may still be galvanized. We test the stops before the new faucet goes on, and we replace what will not operate so the cabinet does not leak behind fresh trim.

Do you repair a dripping faucet in Kerrville or only install a new one?

Both. Faucet repair is the right path when the body is sound and the cartridge, seat, or aerator is the failure. Fixture installation is the better path when the finish is shot, the body is cracked, or the valves behind it are already leaking.

Can a fixture installation include the toilet and the sink on one visit in Kerrville?

Yes. Sink installation, faucet installation, and toilet work can share a visit when the parts are on the truck and the supplies are compatible. We still test each fixture and the line behind it so a pretty install is not sitting on a tired stop.

Why does a new Kerrville faucet still crust up at the aerator?

City of Kerrville water leaves mineral scale on aerators and shower heads even after a new fixture goes in. That is the water, not a bad faucet. We can clean or replace an aerator, and we will tell you if the crust is also a sign the water heater is scaling.

A Kerrville plumber who sets the fixture and tests the stops on the same visit leaves you with a cabinet you can actually use. Call (830) 354-4767 now if a faucet will not shut off or a sink needs to be replaced.

Service ZIPs: 78028, 78025, 78631, 78013, 78010

NEED PLUMBING HELP?

Call Kerrville Plumbing Services Today

From clogged drains and leaking pipes to water heaters, fixture repairs, and other plumbing problems, our team is ready to provide dependable service for your home.